(73) to the Top Frame (55) with a 5/16” x 6” Bolt Holes in the Weight Guides are at the top, asĪttach the upper ends of the Short Weight Guides Lubricate the inside of the holes in the other Top The pin on the Weight Tube is sitting in the pin Press a Weight Tube Bumper (64) into the end of In the Weight Guides are at the top, as shown.Ĩ. Set the Top Weight onto the front stack of Lubricate the inside of the holes in the Top Weight On the Weight Tube is sitting in the pin grooves Insert the Weight Tube into theįront stack of Weights (25). Press a Weight Tube Bumper (64) into the end of a Be sure that the pin grooves are on the indicated side of each stack of Weights.īe careful not to tip either stack of Weights (25) until step 8 is complete.ħ. Stack eight Weights (25) onto each set of Weight Bumpers (19). Set two Weight Bumpers on the bracket on the Stabiliser (5). Set two Weight Bumpers (19) on the bracket on the Base (4) as shown. Tighten all 5/16” Nylon Locknuts (3) used in steps 1–5.Ħ. Hand tighten two 5/16” Nylon Locknuts (3) onto the Carriage Bolts.Īttach the other end of the Leg Press Seat Frame (79) to the Leg Press Upright (56) with two 5/16” x 2 3/4” Bolts (11), two 5/16” Washers (8), and two 5/16” Nylon Locknuts (3).Īttach the Handle (82) to the Leg Press Seat Frame (79) with two 5/16” x 2 1/2” Carriage Bolts Slide the Leg Press Seat Frame (79) onto the indicated 5/16” x 2 1/2” Carriage Bolts (1) in the Stabiliser (5). Press two Round Inner Caps (75) into the top of the crossbar.Īttach the Top Frame (55) to the Rear Upright (74) and the Leg Press Upright (56) with two 5/16” xĢ 3/4” Bolts (11) and two 5/16” Nylon Locknuts (3).Īttach the Top Frame (55) to the Front Upright (42) with two 5/16” x 2 3/4” Bolts (11), two 5/16” Washers (8), and two 5/16” Nylon Locknuts (3).ĥ. Press a 1 3/4” Square Inner Cap (44) into each end of the crossbar on the Top Frame. Press a 2” Square Inner Cap (27) into the end of the Top Frame (55). Remove the PART IDENTIFICATION CHART and the PART LIST/EXPLODED DRAWING before beginning assembly.Ĥ. Note: A PART IDENTIFICATION CHART and a PART LIST/EXPLODED DRAWING are attached at the centre of this manual.
0 kommentar(er)
